Your cart

How to build your own gabion firepit in 7 simple steps

How to build your own gabion firepit in 7 simple steps

Guaranteed DIY & Creative!

There's nothing cozier than flames crackling in your homemade firepit in your garden. Picture roasting potatoes, and there's nothing more relaxing than flames crackling in your homemade firepit in your garden. Picture roasting potatoes and corncobs on those cool evenings! With a few simple tools and materials, you can create your firepit. Find out how to build your gabion firepit in 7 simple steps.

Guaranteed DIY & Creative!

Materials needed:

• three panels of 2x1m Rhinoweld welded gabion mesh • 2 panels of 2x 0.5m Rhinoweld welded gabion mesh
• 1-2 tons of limestone rocks • 1200mm Steel firepit bowl
• Zinc Paint • 4m² Filtermaxx geotextile

Tools you need:

https://stratagreen.com.au/• Spirit Level• Angle grinder with cut off wheel or bolt cutters
• Welder and helmet• Paint brush

Let' s get started! Read below how to build your own gabion firepit in 7 simple steps.

1.Scope out a place in your backyard away from burnable materials and plants

Ensure the surface is flat and level. Here, we built our fire pit on the sand, but you can build a fire pit on any surface.

2.Cut the Rhinoweld welded gabion mesh base to the required diameter.

In this case, the diameter was 1300 cm. We recommend using an angle grinder with a cutoff wheel, but bolt cutters also work. Then, tack weld the base to the outside, as seen below.

3. When happy with location, lay geotextile under the base as a filter barrier.

Start filling the Rhinoweld welded mesh gabions with your desired stone. In this case, we used about two trailers of limestone biscuits from Soil aint Soils. Note: This is a critical part in building your own gabion fire pit to stand out and look neat. Undoubtedly, the more carefully the rocks are layered, the nicer it will look, so take your time here and use flat rocks where desired.

4. Cut the top circle (1300 diameter) and track-weld to the sides using the welder.
5. Next. cut the inner circle so the fire bowl can be recessed.

Coat the welds and cut ends with zinc paint to protect the mesh from rusting.

6. Complete the stone laying ensuring a tight fit.

You may need to trim some rock to make them fit perfect. Use a hammer or chisel to shape the stone.

7.Place the steel firepit bowl in the recess.

The bowl should sit on the mesh and shouldn’t rock.
That’s it! Now it’s time to invite family & friends, inspire them to consider an upgrade to their garden too!
Light a fire, keep warm and bring on the marshmallows!! Isn't it a great idea to build your own firepit?

For tips & tricks regarding your specific situation, feel free to reach out to our firepit expert Gavin Fawkes on 1300 866 367 or email gavin.fawkes@stratagreen.com.au. StrataGreen specialises in landscaping supplies in Perth and across Australia. Find out more about StrataGreen.

Previous post
Next post